Monday, October 26, 2009

Bill and His Cross





Bill was ready to take his cross to downtown Huntington, WV. He walked into Starbucks, got his coffee and then grabbed a seat outside. When we planned this event we figured we would have about an hour or so till we had to leave and thats how it all worked out. Bill had a chance to speak with several people. He spoke with a Methodist Pastor and a few other people before he was asked to leave. We went to our next location. I read the Project Ezra scripture verses for the week and did some open air. Bill did his first open-air!! He was a natural at it too...he sounded like he's been doing it for years. We all alternated holding the cross as we each open aired. What an exciting day! Many heard the Truth that day, many seeds were planted, and our prayer is that God would draw them to Himself.
Keep Fishin!!!!

Making the Crosses









Having been inspired and encouraged by Tony Miano and Paul Latour I decided to make a few crosses for our fishing team in Huntington, WV. This is a short description of how I did it and what I used.

I started out with my Materials List:
(this is for one cross)

1 - 1 x 6 x 10 Pine Select (no knots)
1 - 1 1/2 x 1/4 carriage bolt, wing nut and washer
1- English Chestnut Minwax stain
1 - Spray Polyurethane
1 - 4 inch Vinyl Lettering

I started out by cutting my boards to the desired length. The vertical piece measures 4 foot and the horizontal piece measures 3 foot.

Using a dado blade I cut a 1/4 dado in the vertical piece. This will provide stability for the horizontal piece when the cross is in its open position.









Center the horizontal piece in the vertical piece and drill a centering hole.

Drilled a 3/4 hole using a forstner bit to recess the bolt.

Next I made a circle hole jig to make the inlay to hide the bolt.











I mixed some JB Weld to add some additional support to the bolt and to keep the inlay piece from popping out.













Insert the inlay and let it dry for at least 24 hours.

















Sand the crosses with some fine sandpaper. Theres not too much sanding due to the good grade of lumber that Pine Select is.













Add a coat of English Chestnut Stain and let dry for 24 hours.














Apply three coats of polyurethane. I used a commercial sprayed type but a wipe on or brush on type would work just as well. This would protect the crosses from the elements and give a good surface for the letters to adhere to.

I used some blue tape to help be sure the letters were all lined up properly.

The cross weighs 5.4 lbs.

This woodworker had a lot of fun making these crosses......but its alot more fun using them and seeing them used all over town for the glory of God.
Thanks again to Paul and Tony for the inspiration in this design.

Keep Fishin!!

Wednesday, October 7, 2009

Street Evangelism